|
This bracelet design is made to compliment our
30 Degree Wire Spirals Earrings.
We suggest that if you make both this bracelet and the 30 Degree Wire
Spiral Earrings that you make them with the same 6mm Swarovski Crystal
Beads. This bracelet is a larger and bolder bracelet than we
usually make. The picture below is very close to life size, as
this bracelet is 7.5" long and about 1 1/4" wide.
This bracelet is very strong because we have oriented the double spiral
wire component on the strong axis of the piece. If you were to
grasp the double spiral wire component by the two spirals at either end
and pull, you might be able to pull this wire component apart. If,
by contrast, you grasp the double spiral wire component by the sides of
the piece and pull (the same orientation as shown in the bracelet below)
you will find that the wire component is very strong and can't be pulled
apart.
This bracelet below was made on our WigJig Centaur, although this pattern
could be modified to work on our WigJig Olympus or Olympus Lite.
This is an advanced beginner's jewelry making project.
 |
