How to Make Cubic Zirconia Earrings Jewelry Making Technique -- Page 1

HOME   JEWELRY MAKING INSTRUCTIONS   WIGJIG UNIVERSITY   NEWSLETTER   GIFT IDEAS   WIGJIG STORE
VIEW OUR BEADS  BLING  BOOKS  CHAIN  FINDINGS  MISC  SUPPLIES  THREAD  JEWELRY TOOLS  WATCHES  WIRE
[jewelry-making/curtain/cz-earrings/CZ-Earrings-header.htm]

Making Cubic Zirconia or CZ Earrings Jewelry Making TechniqueJewelry Making Technique for Making Earrings from Cubic Zirconia Pendants Mounting CZ Pendants in Earrings or Necklaces Jewelry Making TechniqueThis jewelry making technique shows three approaches for making earrings using Cubic Zirconia "Ax" style pendants.  In our WigJig Internet store, these CZ pendants that are appropriate for these three techniques are our 18mm Ax Pendants.  The 18mm Ax Pendants are shown here left and right.  You can view our selection of these types of CZ pendants here.

The three techniques that we will discuss are in the order shown above-right, making a wrapped link, making a figure 8 connector or modified figure 8 connector and using a large jump ring.  The most secure of the three approaches is the wrapped link shown near-right.  The one approach that is the easiest to accomplish is the jump ring technique shown far-right.   
 

Jewelry Making Supplies Tools Required

Skills Required:

  • Ability to make a loop in wire.
  • Ability to cut wire with with a flush cutter.
  • Ability to straighten wire with nylon jaw pliers.
  • Ability to make a wrapped loop.
  • Ability to make a jump ring
  • Ability to make a figure 8 connector and a modified figure 8 connector. 

Page 1                    Next Page

[jewelry-making/curtain/cz-earrings/CZ-Earrings-header.htm]

Return to Beads, Jewelry Making Tools, Beads, Wire and Jewelry Supplies by WigJig Home

See our selection or beads, jewelry making supplies, wire and jewelry tools.

IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted by WigJigQuestions/Comments? 
WigJig is a registered trademark - Last modified:
08/09/2008