Classic Pearl Beads Necklace and Bracelet Jewelry Making Project    Page 7

HOME   JEWELRY MAKING INSTRUCTIONS   WIGJIG UNIVERSITY   NEWSLETTER   GIFT IDEAS   WIGJIG STORE
VIEW OUR BEADS  BLING  BOOKS  CHAIN  FINDINGS  MISC  SUPPLIES  THREAD  JEWELRY TOOLS  WATCHES  WIRE

Classic Pearl Beads Necklace and Bracelet Jewelry Making Pages:  1    2    3    4    5    6    7    8     Large Picture
View our Free Jewelry Making Instructions     Jewelry Making Skills     Jewelry Making Supplies     Jewelry Making Tools

Alternative Design:

This alternative design is a new configuration for the catch portion of the clasp used with this necklace.  The instructions for the hook portion of the clasp remains the same as described in page 3, but the catch is changed.  The combined hook and catch clasp can be seen at right.  Instructions for making this catch are provided below.
 

Hook and Clasp Jewelry Making Project

Step A:  Cut a 4 inch segment of 20 gauge wire and make a loop in the flush end of this wire segment (not the sharp end). 

Step B:  Straighten this wire segment. 

Step C:  Position a metal peg and a 1/4 inch Super Peg in your jig separated by about 1/2 inch as shown at right.  Place the loop in your wire on peg one as shown.
 

Peg Pattern for hook and clasp jewelry making project.
Step C

Step D:  Wrap the wire around peg 2 as shown.

Hook and Clasp Jewelry Making Project Step D
Step D

Page 7                    Next Page

Classic Pearl Beads Necklace and Bracelet Jewelry Making Pages:  1    2    3    4    5    6    7    8     Large Picture
View our Free Jewelry Making Instructions     Jewelry Making Skills     Jewelry Making Supplies     Jewelry Making Tools

WigJig Jewelry Making Tools, Beads, Wire and Jewelry Supplies Home
See our selection of beads, wire and jewelry tools.

IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig.  Questions/Comments? 
WigJig® is a registered trademark - Last modified: 09/04/2008