|HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE|
|VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE|
Step 4: With your last 6mm crystal pearl bead in place on the bead
stringing wire, thread a 2x2mm crimp bead onto the bead stringing wire,
followed by the other end of the guard chain. Now thread the bead
stringing wire through the loop in the other end of your commercial clasp
and back through the crimp bead. Pull all the slack out of the bead
stringing wire so that there is very little bead stringing wire showing
where it loops through the clasp and all your beads are snug, one against
the other. Now try this bracelet on to make sure that the size is
correct. Add or remove beads if necessary so that the bracelet fits
Step 5: Crimp the crimp bead to lock your beads in place. Cut
the excess bead stringing wire using your stainless steel cutter.
Step 6: Now try your new classic pearl beads bracelet on. This
jewelry making project is done.
I suggest that you consider the wire chandelier earrings, shown at right, as a complement to your new necklace and bracelet. Instructions for making these earrings can be found by selecting the picture at right.
Alternative design configurations are shown on the following web page.
Page 6 Next Page
Making Tools, Beads, Wire and Jewelry Supplies Home
See our selection of beads, wire and jewelry tools.
IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig. Questions/Comments?
WigJig® is a registered trademark - Last modified: 09/04/2008