Classic Pearl Beads Necklace and Bracelet Jewelry Making Project    Page 2

HOME   JEWELRY MAKING INSTRUCTIONS   WIGJIG UNIVERSITY   NEWSLETTER   GIFT IDEAS   WIGJIG STORE
VIEW OUR BEADS  BLING  BOOKS  CHAIN  FINDINGS  MISC  SUPPLIES  THREAD  JEWELRY TOOLS  WATCHES  WIRE

Classic Pearl Beads Necklace and Bracelet Jewelry Making Pages:  1    2    3    4    5    6    7    8     Large Picture
View our Free Jewelry Making Instructions     Jewelry Making Skills     Jewelry Making Supplies     Jewelry Making Tools

Step 1:  This jewelry making project starts by making two Flemish Spiral wire components which will ultimately become the clasp for the necklace.  The peg pattern for making this component is shown below, right.  It requires two regular metal pegs and two 3/16" Super Pegs.  Position your pegs in your jig as shown.  (The WigJig Delphi is shown, but this pattern can also be made in the Olympus or Olympus-Lite.)
 

Classic Pearl Beads Necklace Jewelry Making Project
   
Pearl Necklace

Step 2:  Cut two three inch long segments of 18 gauge wire.  1/2 hard wire works best if available.

Step 3:  Make a loop in one end of the wire using your round nose pliers (or step jaw pliers if you have them). 

Classic Pearl Beads Necklace Jewelry Making Project Peg Pattern on WigJig Delphi

Step 4:  Straighten the wire.  Use your nylon jaw pliers if you have them. 

Step 5:  Wrap the wire around the pegs as shown above.

Page 2                        Next Page

Classic Pearl Beads Necklace and Bracelet Jewelry Making Pages:  1    2    3    4    5    6    7    8     Large Picture
View our Free Jewelry Making Instructions     Jewelry Making Skills     Jewelry Making Supplies     Jewelry Making Tools

WigJig Jewelry Making Tools, Beads, Wire and Jewelry Supplies Home
See our selection of beads, wire and jewelry tools.

IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig.  Questions/Comments? 
WigJig® is a registered trademark - Last modified: 09/04/2008