|HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE|
|VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE|
Deluxe Duplex Bracelet
|Step 1b: Cut and make a loop in one end of a wire segment 4 1/8
inches long. Use 18 gauge for the first bracelet you make as it will
be easier. Once you are familiar with the design, 16 gauge will make
a slightly bolder look in your finished bracelet. Should you choose
to use 16 gauge wire, you will need to use a WigJig Olympus or Olympus-Lite
to make the duplex wire components. There is not adequate room on
the WigJig Delphi for 16 gauge wire.
Step 2b: Straighten the wire by pulling it repeatedly through the jaws of nylon jaw pliers.
Step 3b: Follow steps 1 through 12 described beginning in
page 2 for making the duplex wire component.
Make five identical duplex wire components.
Duplex wire Component
|Step 4b: Cut and make a loop in one end of a wire segment 2
Step 5b: Follow steps 15 through 18 as shown starting in page 4 to make the 2:1 or end wire component. Make two of these components.
Page 13 Next Page
Making Tools, Beads, Wire and Jewelry Supplies Home
See our selection of beads, wire and jewelry tools.
IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig. Questions/Comments?
WigJig® is a registered trademark - Last modified: 09/04/2008