Duplex Wire Bracelet with Beads Jewelry Making Project Page 9

HOME   JEWELRY MAKING INSTRUCTIONS   WIGJIG UNIVERSITY   NEWSLETTER   GIFT IDEAS   WIGJIG STORE
VIEW OUR BEADS  BLING  BOOKS  CHAIN  FINDINGS  MISC  SUPPLIES  THREAD  JEWELRY TOOLS  WATCHES  WIRE

Duplex Wire Bracelet with Beads Jewelry Making Project: 1   2   3   4   5   6   7   8   9   10   11  
12   13   14   15   16   17   18   19   20

View our Free Jewelry Making Instructions     Jewelry Making Skills     Jewelry Making Supplies     Jewelry Making Tools

Now we need to connect loop 12 in the end wire segment to the commercial clasp (I) and the guard chain (J).  There are three good ways to do this.  You can open loop 11 in the end wire segment and slide the loop in the commercial clasp and one link of the guard chain onto the end wire segment and finally into position in loop 12, or you can use a medium jump ring to connect between loop 12 and the loop in the commercial clasp, or you can use a figure 8 connector
 

End Segment of Duplex Bracelet Jewelry Making Project

Step 32:  Before choosing how to connect your clasp and guard chain to finish your bracelet, measure your bracelet to this point.  If your bracelet is over 7 inches long, connect your clasp directly to the end wire segments by opening either loop 10 or 11 and sliding the clasp and guard chain into position in loop 12.  If your bracelet is 7 inches long or less, use either a pair of jump rings or figure 8 connectors.  Your goal is to make your bracelet about 7 1/2 inches long when completed.  Finish this bracelet by connecting your 2 1/2 inch long guard chain and clasp to both ends of your bracelet. 

Finished Duplex Bracelet Jewelry Making Project

Page 9                        Next Page

Duplex Wire Bracelet with Beads Jewelry Making Project: 1  2  3  4  5  6  7  8  9  10  11  12  13  14  15  16  17  18  19  20

Return to Jewelry Making Tools, Beads, Wire and Jewelry Supplies by WigJig Home
See our selection of jewelry making supplies including beads, wire and jewelry tools.

IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig.  Questions/Comments? 
WigJig® is a registered trademark - Last modified: 09/04/2008