|HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE|
|VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE|
Step 17: Now we are ready to make our 2-1 end wire component. Place pegs 8, 9 and 10 in your jig as shown at right. We make this 2-1 end wire component using the 3" segments of wire that we cut in the first step.
Step 20: Remove your wire from your jig. The wire component should appear as shown below center-left.
Step 21: Cut the excess wire using your flush cutter. Close the final loop using your bent chain nose pliers.
Step 22: Using your bent chain nose pliers grasp the wire at the point where the loops made on pegs 8 and 10 begin and bend the wire 90 degrees. On the initial loop, bend the wire 90 degrees counter-clockwise. On the final loop, bend the wire 90 degrees clockwise. When completed the wire component should appear as shown below-right. Make two 2-1 end wire components using these steps.
Prior Page Page 6 Next Page
Return to Beads, Jewelry Making Tools, Beads, Wire and
Jewelry Supplies by WigJig Home
See our selection or beads, jewelry making supplies, wire and jewelry tools.
All content on this web site is copyrighted© by WigJig®. Questions/Comments?
WigJig is a registered trademark - Last modified: 03/19/2008