|HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE|
|VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE|
Step O: At this point, what we have can be used as a large head pin for beads with larger holes, or it can be used as as a decorative metal dangle. If you want to use it as is, without beads, you are ready to make a loop at the top. If you want to add beads, add your beads and then make a loop at the top. Our instructions for making a loop at the top of this wire component can be found here. These instructions show the approach for making an open loop at the top as shown below, center-left, or for making a wrapped loop at top as shown below center-right or far right.
Step P: With the loop completed you are ready to add this wire component to an earring or necklace. For earrings the orientation of the top loop shown above will be appropriate. For a necklace, you will probably want to twist the top loop 90 degrees so that it can be threaded on a necklace with the proper orientation.
On the following web page we provide instructions for making a similar jewelry design. See the picture at right for our Larger Leaf wire component.
Prior Page Page 16 Next Page
Return to WigJig Jewelry Making Tools, Beads, Wire and
Jewelry Supplies Home
See our selection jewelry making supplies, beads, wire and jewelry tools.
All content on this web site is copyrighted© by WigJig®. Questions/Comments?
WigJig is a registered trademark - Last modified: 08/18/2010