|HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE|
|VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE|
Step 6: Now we need to flip the wire component over and replace it on the jig as shown at right.
Step 7: Wrap the wire around peg 2 as shown below-center.
Step 8: Now add peg 5 to your pattern and wrap the wire around peg 5 as shown below-center.
Step 9: Remove the wire from your jig. At this point the wire component should appear as shown below-right.
Step 10: Using your bent chain nose pliers, grasp the wire tail (the long end of the wire without the initial loop) just prior to the center of the clubs component and bend the wire up as shown at right.
These free jewelry making instructions continue on the next web page.
Prior Page Page 10 Next Page
Return to WigJig Jewelry Making Tools, Beads, Wire and
Jewelry Supplies Home
See our selection jewelry making supplies, beads, wire and jewelry tools.
All content on this web site is copyrighted© by WigJig®. Questions/Comments?
WigJig is a registered trademark - Last modified: 07/02/2010