Queen of Clubs Wire & Beads Earrings Jewelry Making Project -- Page 9

HOME   JEWELRY MAKING INSTRUCTIONS   WIGJIG UNIVERSITY   NEWSLETTER   GIFT IDEAS   WIGJIG STORE
VIEW OUR BEADS  BLING  BOOKS  CHAIN  FINDINGS  MISC  SUPPLIES  THREAD  JEWELRY TOOLS  WATCHES  WIRE

Queen of Clubs Wire and Beads Earrings Jewelry Making Project:  1    2    3    4    5    6    7    8    9    10    11    12    13    14    15    16    17   
View our Free Jewelry Making Instructions     Jewelry Making Skills     Jewelry Making Supplies     Jewelry Making Tools

 

Bold Round Clubs Jewelry Wire & Beads Pendant

Making the pendant shape shown at right is a more advanced project than the Queen of Clubs Earrings we discussed in the prior 8 pages. 

Step 1:  Using your nylon jaw pliers, Straighten a segment of wire 6 inches long.  If your beads have normal size holes, use 20 gauge wire.  If you have beads with larger than normal holes, you can use 18 gauge wire.  Please note that everyone should practice making this pendant with 20 gauge wire since it is much easier to make with 20 gauge wire. 

Step 2:  Using your flush cutter, cut this segment of wire. 

Step 3:  Using your fine step jaw pliers or your round nose pliers, make a loop in one end of this wire.  This loop will ultimately be cut off so it is not important that the loop is fully closed.  Step 3 to Bold, Round Clubs Wire and Beads Pendant Jewelry Making Project

Step 4:  Position your pegs in your jig as shown at right.  The jig used in this picture is the WigJig Delphi.  There are two regular metal pegs (peg 1 and 4) and three 3/16" Super Pegs (pegs 2, 3 and 5).  (Please don't look for logic in this number scheme as you won't find it.  Hopefully, you can just accept that the author wasn't paying attention when I numbered these pegs.)  This same pattern can also work on the WigJig Centaur and you can modify the pattern slightly for the WigJig Olympus Lite or WigJig OlympusPlease select here to print a PDF template of this peg pattern.  Please turn page scaling off when you print. 

Step 5 to Round Bold Clubs Beads & Wire Pendant Jewelry Making ProjectStep 5:  First, remove peg 5 so that it won't be in your way.  Then place your initial loop on peg 1 and wrap the wire around peg 3 as shown at right. 

These free jewelry making instructions continue on the next web page. 

Prior Page                    Page 9                    Next Page

Queen of Clubs Wire and Beads Earrings Jewelry Making Project:  1    2    3    4    5    6    7    8    9    10    11    12    13    14    15    16    17   
View our Free Jewelry Making Instructions     Jewelry Making Skills     Jewelry Making Supplies     Jewelry Making Tools

Return to WigJig Jewelry Making Tools, Beads, Wire and Jewelry Supplies Home

See our selection jewelry making supplies, beads, wire and jewelry tools.

IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted by WigJigQuestions/Comments? 
WigJig is a registered trademark - Last modified: 07/02/2010