|HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE|
|VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE|
Alternative Designs Continued:
Step 10: Place peg 5 into your jig as shown below-left.
You won't need to flip the wire component over for this step.
Step 11: Wrap the wire around peg 5 as shown
below-right. Again, push the wire with the tip of the index finger
on your dominant hand.
Step 12: Remove the wire component from your jig. At this point, your wire component should appear as shown below-left.
Step 13: Cut the excess wire and close the final loop. Please seethe picture below-right.
These free jewelry making instructions continue on the following web page.
Prior Page Page 21 Next Page
WigJig Jewelry Making, Beads, Wire, and Jewelry Supplies Home
See our selection of beads, wire and jewelry tools.
All content on this web site is copyrighted© by WigJig. Questions/Comments?
WigJig® is a registered trademark - Last modified: 03/17/2011