Page 16            Beaded Chandelier Earrings Jewelry Making Project

HOME   JEWELRY MAKING INSTRUCTIONS   WIGJIG UNIVERSITY   NEWSLETTER   GIFT IDEAS   WIGJIG STORE
VIEW OUR BEADS  BLING  BOOKS  CHAIN  FINDINGS  MISC  SUPPLIES  THREAD  JEWELRY TOOLS  WATCHES  WIRE

Beaded Chandelier Earring Jewelry Making Project Pages:  1    2    3    4    5    6    7    8    9    10   
11    12    13    14    15    16    17    18    19    20    21    22    23    24
     Jewelry Making Tools
View our Free Jewelry Making Instructions     Jewelry Making Skills     Jewelry Making Supplies

Alternative Designs Continued:

The design for these earrings is very similar to the earrings on Page 15, only this design uses a new component similar to the five loop V shaped component.  To make this component, you need 3 1/2 inches of wire and the seven metal pegs shown in the center below, right.  Make the first four loops, starting with two pegs and adding the third and fourth pegs as you go.  Once you have completed the center loop, remove the wire component from the jig and add the remainder of the metal pegs.  Now replace the wire on the jig in the mirror image position (flipped over).  Remove the first two pegs and wrap the wire around the third peg.  Add the second peg and wrap the wire around it.  Add the third peg and wrap the wire around it.  Remove the wire from the jig and cut the excess wire.  Close the final loop and you are ready to go. 
 

Two Tier Emerald Beads Chandelier Earrings Jewelry Making Project

Making these earrings is similar to the making the prior earrings only no bugle beads are used for spacing.  8 head pins are required for each earring along with ten 6mm beads and 8 inches of 22 or 24 gauge wire.  Wrapped loops using the 22 or 24 gauge wire are required to connect the outside loop on the top five loop V shaped wire component to the top, outside loops on the seven loop V shaped wire component.  These wrapped loops are connected to the seven loop V shaped wire component by opening the beginning and ending loops on this component using your bent chain nose pliers.  Close these loops after the wrapped loop is connected in the proper orientation. 

Our professional earring critic really likes this design also. 

Peg Pattern for Two Tier Emerald Beads Chandelier Earrings Jewelry Making Project

Prior Page                    Page 16                 Next Page

Beaded Chandelier Earring Jewelry Making Project Pages:  1   2   3   4   5   6   7   8
9   10   11   12  13   14   15  16   17   18   19   20  21   22   23   24           Jewelry Making Techniques

WigJig Jewelry Making, Beads, Wire, and Jewelry Supplies Home
See our selection of beads, wire and jewelry tools.

IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig.  Questions/Comments? 
WigJig® is a registered trademark - Last modified: 09/04/2008