|HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE|
|VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE|
Step 9: Now using your round nose pliers. Grasp the loop on either end of the handle wire component and bend it, one at a time, into an eye loop. The technique for doing this is shown here. When done, the handle should appear as shown at right.
|Step 10: Now one at a time, we need to bend these eye loops so that they are perpendicular to the rest of the handle wire component. In the picture at right, you can not see the two loops because they are vertical while the rest of the wire component is horizontal.||
|Step 11: To help make both bend in this wire component as symmetrical as possible, replace the wire component onto the jig as shown at right and bend both loops up until they just barely touch peg 1 or 5. Generally, this requires some bending of the wire on the side that was made second (against peg 4).||
Prior Page Page 8 Next Page
WigJig Jewelry Making, Beads, Wire, and Jewelry Supplies Home
See our selection of beads, wire and jewelry tools.
IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig. Questions/Comments?
WigJig® is a registered trademark - Last modified: 09/04/2008