|HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE|
|VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE|
Alternative Designs Continued:
Step 16: Push the wire up and over the upper jaw of your round nose pliers. This is the first step in making a loop.
Step 17: Relax your grip on the wire and reposition the wire as shown below-left. This will allow you to complete the loop in the next step.
Step 18: Push the wire the rest of the way around to complete a loop. View the loop before removing your pliers. Adjust the loop left or right so that it is centered.
Step 19: Remove the wire from your pliers. At this point, your wire should appear as shown below center-right.
Step 20: Add your clasp to the loop. You may need to open the loop slightly by bending one side of the loop up with your bent chain nose pliers.
These instructions continue on the next page
Prior Page Page 16 Next Page
WigJig Jewelry Making Tools, Beads, Wire and
Jewelry Supplies Home
See our selection jewelry making supplies, beads, wire and jewelry tools.
All content on this web site is copyrighted© by WigJig®. Questions/Comments?
WigJig is a registered trademark - Last modified: 05/19/2009