|HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE|
|VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE|
Triangular Jewelry Wire Bail (Continued):
Step 13: Add your pendant bead or gemstone to the long wire tail as shown at right. Slide the pendant all the way onto the wire.
Step 14: With the pendant or gemstone pushed as far to the left as possible in the picture below-left, bend the wire tail up and ultimately across the top of the pendant bead or gemstone as shown. You can push the wire with your thumb or forefinger. or some my find that pushing with the jaws of your bent chain nose pliers will help. Try to push the wire so that the initial wire segment and the long wire tail are on the same side of the wire triangles if possible.
Step 15: Grasp the wire with your bent chain nose pliers as shown below-center.
Step 16: While holding the wire in your pliers, bend the wire tail until it is parallel to the beginning wire segment but pointing in the opposite direction. See the picture below-right.
These instructions continue on the next web page.
Prior Page Page 23 Next Page
Return to Beads, Jewelry Making Tools, Beads, Wire and
Jewelry Supplies by WigJig
See our selection or beads, jewelry making supplies, wire and jewelry tools.
All content on this web site is copyrighted© by WigJig®. Questions/Comments?
WigJig is a registered trademark - Last modified: 02/15/2009