|HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE|
|VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE|
Triangular Bail (Continued):
Step 9: Pull the initial segment of wire up and over while holding the triangles of wire in position on the pegs in your jig. This step gets the wrap of wire started in the correct position. See the picture at right.
Step 10: Remove the wire from your jig. It should appear as shown below-left.
Step 11: Using your bent chain nose pliers grasp the long wire tail immediately below the triangles and bend the wire about 30 to 45 degrees as shown below-center.
Step 12: Grasp the wire at the 30 to 45 degree bend with your bent chain nose pliers and bend the wire so that it is parallel to the beginning wire segment as shown below-right.
These instructions continue on the next web page.
Prior Page Page 22 Next Page
Return to Beads, Jewelry Making Tools, Beads, Wire and
Jewelry Supplies by WigJig
See our selection or beads, jewelry making supplies, wire and jewelry tools.
All content on this web site is copyrighted© by WigJig®. Questions/Comments?
WigJig is a registered trademark - Last modified: 02/15/2009