Making a Triangular Jewelry Wire Bail Finding --
An Advanced Beginner's Jewelry Making Technique -- Page 20

HOME   JEWELRY MAKING INSTRUCTIONS   WIGJIG UNIVERSITY   NEWSLETTER   GIFT IDEAS   WIGJIG STORE
VIEW OUR BEADS  BLING  BOOKS  CHAIN  FINDINGS  MISC  SUPPLIES  THREAD  JEWELRY TOOLS  WATCHES  WIRE

Making a Jewelry Wire Bail Finding -- Jewelry Making Technique  Pg1   Pg2   Pg3   Pg4   Pg5   Pg6   Pg7  
Pg8   Pg9   Pg10   Pg11   Pg12   Pg13   Pg14   Pg15   Pg16   Pg17   Pg18   Pg19   Pg20   Pg21   Pg22   Pg23
Pg24   Pg25   Pg26   Pg27   Pg28  Jewelry Making Skills  Jewelry Making Supplies  Jewelry Making Tools

3 Peg Jewelry Wire Bail Jewelry Making FindingTriangular Jewelry Wire Bail Jewelry Making ProjectAlternative Configuration (Continued):

Triangular Jewelry Wire Bail Shown at right

Our Triangular Jewelry Wire bail is another way to make a pendant out of a larger gemstone or CZ.  Shown at right are two pendants, one with a side-to-side hole and one with a front-to-back hole.  These instructions will cover how to make a bail finding for either bead.  The bead shown near right is our 22x30mm Pear Cubic Zirconia Pendant and can be found in the Pendants sub-department to our "More Bling" area of our Internet store.  The pendant at right is a product that we have on order and hope to add to our Internet store in May 2009.  Our instructions for how to make this bail finding begin below.  These instructions use our WigJig Centaur or Cyclops and 4 inches of 22 gauge wire.  This is an advanced beginners to intermediate jewelry making project. 

 Step 1:  Using your nylon jaw pliers straighten a segment of 22 gauge wire 4 inches long.  1/2 hard wire will work better than soft wire if you have it available.  Our 22 gauge non-tarnish brass Artistic Wire, Item 0523, is good wire for this project.  Triangular Jewelry Wire Bail Jewelry Making Finding Step 4

Step 2:  Using your flush cutter cut that segment of wire to a length of 4". 

Step 3:  Using your fine step jaw pliers, make a "P" loop in the end of the wire sized so that it will fit on a peg in your WigJig Cyclops or Centaur. 

Step 4:  Place three regular metal pegs in a WigJig Cyclops or Centaur as shown at right.  Place the "P" loop in your wire on the furthest left peg as shown. 

These instructions continue on the next web page. 

Prior Page                    Page 20                    Next Page

Making a Jewelry Wire Bail Finding -- Jewelry Making Technique  Pg1   Pg2   Pg3   Pg4   Pg5   Pg6   Pg7  
Pg8   Pg9   Pg10   Pg11   Pg12   Pg13   Pg14   Pg15   Pg16   Pg17   Pg18   Pg19   Pg20   Pg21   Pg22   Pg23
Pg24   Pg25   Pg26   Pg27   Pg28  Jewelry Making Skills  Jewelry Making Supplies  Jewelry Making Tools

Return to Beads, Jewelry Making Tools, Beads, Wire and Jewelry Supplies by WigJig

See our selection or beads, jewelry making supplies, wire and jewelry tools.

IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted by WigJigQuestions/Comments? 
WigJig is a registered trademark - Last modified:
02/15/2009