|HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE|
|VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE|
Alternative Configuration (Continued):
Step 20: Wrap the wire around until the gap between the circle and the top of the pendant is filled with wrapped wire. This will take about 1 to 2 full wraps of wire. See the picture at right. Once you have completed the wraps, cut the excess wire with your flush cutter. After cutting the excess wire, there will be a small wire tail that sticks up. To flatten this short wire tail, grip the circle with one pair of bent chain nose pliers and squeeze and twist the wire tail until it is flat.
The finished hand-made jewelry wire bail is shown at left and below. The pendants shown her are actually smaller than they appear in the pictures. They are our 7x10mm pendant beads and can be found in our WigJig store by selecting here.
These instructions continue on the following web page with our instructions for making a teardrop shaped bail finding as shown at right.
Prior Page Page 12 Next Page
Return to Beads, Jewelry Making Tools, Beads, Wire and
Jewelry Supplies by WigJig
See our selection or beads, jewelry making supplies, wire and jewelry tools.
All content on this web site is copyrighted© by WigJig®. Questions/Comments?
WigJig is a registered trademark - Last modified: 12/23/2008