|HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE|
|VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE|
Step 7: Now bend the long wire segment up 90 degrees while continuing to grip the wire firmly with your round nose pliers.
Step 8: Remove the wire from the jaws of your round nose pliers. Adjust the wire so that it appears as shown below-left with no pressure applied.
Step 9: Place this wire component on your jig, on the 3/16 inch Super Peg as shown below-center. We are using the jig and the Super Peg to preserve the round shape of the bail while we wrap the 1 inch wire segment around the longer wire tail.
Step 10: Hold the wire on your jig and in position on the 3/16 inch Super Peg and using your fingers lift the short, 1 inch wire segment and bend it over the longer wire segment as shown below-right. Push the wire down with your fingers as close to the bend in the short wire segment as possible. This helps to keep this wrap tight.
These instructions continue on the following web page.
Prior Page Page 3 Next Page
Return to Beads, Jewelry Making Tools, Beads, Wire and
Jewelry Supplies by WigJig
See our selection or beads, jewelry making supplies, wire and jewelry tools.
All content on this web site is copyrighted© by WigJig®. Questions/Comments?
WigJig is a registered trademark - Last modified: 12/23/2008